| Model |
PEL151-201 |
| InputPower |
0-150W |
InputVoltage
Range |
CR Model:0-200V,CC/CP/CV
Model:1.5-200V |
Input Current Range(Front
/RearTerminal) |
0-30A/0-30A |
Constant
Current
Mode |
Range/Resolution |
LRange:0.3A:0-0.3A/10μA
1.5W max
H Range:30A:0-30A/1mA
150W max |
| Accuracy |
±0.2%of SET±0.3%
of FS(0-40℃) |
| Ripple Noise(1MHz) |
LRange 1mA rms/H
Range 10mA rms |
| Stability |
±0.1%of FS(typ) |
Constant Resistance
Mode |
Range |
HRange:OPEN,1.5k-0.5/
0.498-50mΩ
L Range:OPEN,150k-50/
49.8-5Ω |
| Resolution |
H Range:0.66ms/L
Range:6.6μs |
| Accuracy(23℃±5℃) |
HRange:±0.5% SET
±0.15A+Vin/Rin
L Range:±0.5%SET
±1.5mA+Vin/Rin |
| Ripple Noise(1MHz) |
L Range:1mA rms,H
Range:10m Arms |
| TemperatureFactor |
1000PPM/℃(Vin=5V) |
Constant
Voltage
Mode |
20VRange/200V Range |
1.5-20V/15-200V(CC+CV
Mode,CR+CV Mode) |
Accuracy/Resolution
/Minimum Operating
Current |
±0.1% of SET±0.1%of
FS(0-40℃)/20VRange:
1mV,200V Ragne:10mV/1%
of Constant Current |
Constant
Power
Mode |
Operating Range/Resolution |
1.5WRange:0.03-1.5W/50μW
150W Range:3-150W/5mW |
| Accuracy(23℃±5℃) |
±0.4%SET±1.6%FS±Vin*
Vin/Rinfor Current L
Range)(TEMP factor:
1000PPM/℃(Vin=5V) |
| RippleNoise(1MHz) |
L Range:1mA rms,H
Range:10mA rms |
Short
Mode |
SettingCurrent Value |
0.3/30A(V1 model
CCOV:18A) |
SW Mode
(Preset A<->B) |
Frequency/Accuracy |
1Hz-10kHz/±1.5%SET |
| |
DUTY/SettingAccuracy
/Resolution |
5%-95%/±1.5%SET/
1%STEP |
Through
Rate
Tr/Tf
(1%<->
100%) |
OperatingMode |
CC,CR |
| SettingRange |
CC:10/20/50/100/200/500/
1000/2000μs,CR:OFF/200/500/
1000/2000μs |
| Setting Accuracy |
H:10,20μs:-5μs,L:10,
20μs:±20%,L:50-2000μ
:±30% |
| Soft Start |
OperatingMode |
CC |
SettingRange/
Accuracy |
0.1/1/2/5/10/20/50/
100ms/±30%set+100μs |
Remote
Sensing |
|
2.5Vpar One Way |
| ExternalControl |
Voltage |
0-10V(Offset gain
Adjustableat Rear
Panel.)it takes approx.
1 Second for Settings
at CR Mode |
| Resistance |
0-10kΩ(Ittakes approx.1
Second for Settings) |
| Others |
LOADON/OFF,EXT SW |
Series/
Parallel
(Master/
SlaveOperation) |
Connecting Capability |
Maximum4 of Slave
Units plus 1Master Unit |
| Added CuurentDisplay |
Total Value of Slave
Units(s) and Master
Unitare Displayed
at Master Unit Display.
Over Write:2 times/Sec |
Resolution(L
Range/H Range) |
0.1*N/10*N(mA)N:Parallel
Unit Numbers. |
CurrentMonltor
Out |
Linearity |
±1%FS(Offsetand gain are Adjustable.) |
| DC CurrentMeasurement |
Range/(Resolution) |
0.3/30A(0.1/0mA) |
| Accuracy/Repeat |
±0.2%rdg±0.3%FS(0-4℃)/2Times/Sec |
| DC VoltageMeasurement |
Range/Resolution |
20.000/210.00Vmax(Auto Range)/1mV(0-20V)/10mV(20-210V/,Hysteresis at 18/20V |
Accuracy/Repeat/
Temperature
Factor |
20VRange:±0.03%dgt±0.06%FS,200V Range:
±0.03%rdg±0.03%±
0.03%FS(18-28℃)/2
Times/Sec/±0.003%rdg±0.003%FS/℃ |
| Power Measurement |
Range/Resolution |
1.5/150W(1/100mW)/2Times/Sec(Voltage*
Current) |
| UVP(UnderVoltage) |
Range/Resolution
/Accuracy |
OFF,0.5-20V/20mV/±
0.1%SET±40mV(0-40℃) |
| OPP(Over Power) |
Range/Resolution |
L:0.015-1.65W/10mW,
H:15-165W/1W |
| Setting Accuracy |
±0.2%SET±2W(0-40℃) |
| OCP(Over Current) |
SettingRange/Resolution |
L:0.03-0.33A/1.5mA,
H:3-33A/150mA |
| Setting Accuracy |
±0.2%SET±300mA(0-40℃) |
| Protection |
OverVoltage |
Cut Load Off about 230V |
| Over Current,OVer Power |
Automatic ResumeAfter
3 Sec of Load Off |
Reversed
Connection |
Terminate by Parasitic FET |
| Over Heating |
Cut Load OFF at 110℃
at Inside Heat Sink |
| SequenceMemory |
Step/Time/
Resolution |
100/50μs-99h59.99995s,PAUSE,
PASS/50μs/Cycle:1-255 |
| Items |
Discharge Mode Pre-set
A,Band C Value,Pre-setA,
B and C Switch Selection,Discharge Mode,
SHORT ModeON/OFF,LOAD ON/OFF,UVP Setting value,
OCP Setting value,OPP
Setting Value,SoftStart
Setting Value,Tr/Tf
Setting value,SW
Frequency,SW DUTY,CV RANGE,
External Control
Mode(PASS at Auto
Sequence Mode) |
| Enviro-mental Request |
Temperature/
Humidity |
0-40℃20-85%RH/-20-60℃
20-85%RH |
| |
PowerSource/Frequency |
AC90-132V/AC180-250V
48-63Hz |
| |
Power Factor |
Lessthan 75VA |
| |
Isolation |
Primaryto Body:
1500VAC 1 Minute,
Primary to Secondary:
2300VAC 1Minute |
| |
Isolation Resistance |
Primaryto Body ,Primary
to Secondary:500VDC
More Than 10MΩ,Secondary
to Body:250VDCMore
Than 5MΩ |
| |
CoolingMethod |
Cooling Fan |
| |
Dimension/Weight |
W*H*D:213*133*450(mm)
/Approx.6kg |
